Per IS 269-1989, the insoluble residue percentage by mass in ordinary Portland cement shall not be greater than:
A{'text': '1 percent', 'label': 'A'}
B{'text': '8 percent', 'label': 'B'}
C{'text': '4 percent', 'label': 'C'}
D{'text': '15 percent', 'label': 'D'}
Answer & Solution
Correct answer: C. {'text': '4 percent', 'label': 'C'}
1. The IS 269-1989 chemical requirements listed at the top of p. 7 of the source state: 'Insoluble residue percent by mass is not greater than 4 percent.'
2. The same list caps magnesia at 6%, total loss on ignition at 5% and gives the lime saturation factor range.
_Source: IGNOU ET-522 Block-1 Unit-1 Cement, §1.3 (IS 269-1989 chemical requirements), p. 7_
Related questions
In the Standard Consistency test described in §1.10, the percentage of water 'P' is definePer Table 1.5, the maximum permitted FINAL setting time of Ordinary Portland Cement is:Per Table 1.5, the soundness of Ordinary Portland Cement tested by the Le Chatelier methodThe minimum specific surface (by Blaine air permeability) prescribed for Ordinary PortlandOil well cement, per the source, is engineered to remain mobile and then harden under apprAir entraining cement is used principally to improve the resistance of concrete to:Super sulphate cement is produced by inter-grinding granulated blast furnace slag with gypThe cement most ideally suited for mass concrete construction such as dams, per the source