Home › B.Tech Civil › civilengineering › Aggregates › Per IS 383-1970 (Aggregate Impact Value) cited i…
Per IS 383-1970 (Aggregate Impact Value) cited in the source, the impact value for aggregate used in wearing surfaces such as runways and roads shall not exceed:
A{'text': '20 percent by weight', 'label': 'A'}
B{'text': '30 percent by weight', 'label': 'B'}
C{'text': '45 percent by weight', 'label': 'C'}
D{'text': '65 percent by weight', 'label': 'D'}
Answer & Solution
Correct answer: B. {'text': '30 percent by weight', 'label': 'B'}
1. §2.2.6: 'IS 383-1970 specifies that aggregate impact value shall not exceed 45 percent by weight for aggregate used for concrete other than wearing surface and 30 percent by weight for concrete for wearing surfaces such as run ways, roads and pavements.'
2. Hence the wearing-surface cap is 30 percent.
_Source: IGNOU ET-522 Block-1 Unit-2 Aggregates, §2.2.6, p. 21_
Related questions
Per the source, three thermal properties of aggregates are named; the one most important fIn the Mortar Bar Expansion Test (Stanton) cited in §2.2.12, the aggregate is considered HPer §2.3.2(iii), in the Aggregate Impact Value test the standard hammer falls from a heighPer §2.3.2(i), in the Aggregate Crushing Value (ACV) test the aggregate sample is loaded uPer §2.3.1(v) of the source, the specific gravity of an aggregate sample is computed by:Per §2.2.14, the Fineness Modulus range that corresponds to MEDIUM sand is:Per Abrams (cited in §2.2.14), the Fineness Modulus of an aggregate is obtained by:Per the prevention measures in §2.2.12, the alkali content of cement to limit alkali-aggre